Cisco AIR-AP1252AG-A-K9 Hardware Installation Guide - Page 38
Step 1, Mounting Plate Attached to a Surface
View all Cisco AIR-AP1252AG-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Mounting Below a Suspended Ceiling Chapter 2 Installing the Access Point 1 Suspended ceiling T-rail 4 Mounting plate 2 T-rail clips 5 Kepsnut (contains an attached lock washer) 3 Plastic spacer (used with recessed ceiling tiles) Follow these steps to mount your access point on a suspended ceiling: Step 1 Step 2 Step 3 Decide where you want to mount the access point. Attach two T-rail clips to the suspended ceiling T-rail. Use the mounting plate to adjust the distance between the T-rail clips so that they align with the holes in the mounting plate. Note Two pair of mounting holes are provided to allow the access point to oriented parallel to the ceiling tiles or rotated 900 to the ceiling tile (see Figure 2-2). Step 4 Step 5 Step 6 Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 Step 13 Step 14 Step 15 Use a standard screwdriver to tighten the T-rail clip studs in place on the suspended ceiling T-rail. Do not overtighten. If using recessed ceiling tiles, install a plastic spacer on each T-rail clip stud. The spacer's legs should contact the suspended ceiling T-rail. Attach the mounting plate to the T-rail clip studs and start a Keps nut on each stud. Use a wrench or pliers to tighten the Keps nuts. Do not overtighten. Optionally, you can install a 10 AWG copper ground wire to the mounting plate ground stud (see Figure 2-2). The other end of the ground wire should be attached to a building ground connection point. Route your cables through the mounting plate openings or through the ends of the mounting plate. Optionally, you can secure your cables using the supplied tie-wraps and the mounting plate cable tie points. Connect your cables to the access point connectors (see Figure 2-1) before attaching the access point to the mounting plate (see the "Connecting the Ethernet and Power Cables" section on page 2-20). Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely inserted and both module latches are in the locked position (see Figure 2-24). Attach the access point to the mounting plate (see the "Mounting Plate Attached to a Surface" section on page 2-26). If you need additional security, refer to the "Securing the Access Point" section on page 2-27 for additional information. Verify the access point is operating (see the "Powering Up the Access Point" section on page 2-22). 2-10 Cisco Aironet 1250 Series Access Point Hardware Installation Guide OL-8247-03