Cisco AIR-AP1252AG-A-K9 Hardware Installation Guide - Page 98
CDP_PD-2-POWER_LOW: All radios disabled- LOW_POWER_CLASSIC_INJECTOR
View all Cisco AIR-AP1252AG-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Low Power Condition for Lightweight Access Points Chapter 4 Troubleshooting 1250 Series Lightweight Access Points • %CDP_PD-2-POWER_LOW: All radios disabled- LOW_POWER_CLASSIC_INJECTOR_ CONFIGURED_ON_ANOTHER_PORT ()-This message indicates the access point is in low power mode with all radios disabled and has detected a CDP device that is unable to supply sufficient power to the access point. A power injector has been configured, but it is for another port. It is likely that the access point has been relocated and has not been reconfigured for a new power injector. The indicates the CDP device detected by the access point. The indicates the MAC address of the CDP device, typically, the switch port. Note A Cisco power injector might be required. Following the low power status message,an extra message is displayed when using the console port or a Telnet session that identifies the action needed to resolve this low power problem: 1. Verify the required power injector is installed on the new port: (). (where indicates the CDP device detected by the access point and indicates the Ethernet port of the CDP device. • %CDP_PD-2-POWER_LOW: All radios disabled- HIGH_POWER_CLASSIC_NOT_ CONFIGURED inline power source ()-This message indicates the access point is in low power mode with all radios disabled and has detected a Cisco switch that does not support Intelligent Power Management, but should be able to supply sufficient power. The access point must be configured for pre-standard compatibility. The< platform name> indicates the Cisco platform detected by the access point. The indicates the MAC address of the switch port. Note You need to upgrade the software on the Cisco switch to support Intelligent Power Management or configure the access point for pre-standard compatibility. • %CDP_PD-2-POWER_LOW: All radios disabled-INJECTOR_CONFIGURED_BUT_FAILS_ VERIFICATION ()-This message indicates the access point is in low power mode with all radios disabled and a power injector has been configured but has not been detected by the access point. The< platform name> indicates the Cisco platform detected by the access point. The indicates the MAC address of the switch port. 4-10 Cisco Aironet 1250 Series Access Point Hardware Installation Guide OL-8247-03