Cisco N5K-C5010P-BF Troubleshooting Guide - Page 103
Cisco Fabric Services, Overview, Verifying CFS using CLI
UPC - 882658212208
View all Cisco N5K-C5010P-BF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Chapter 5 Troubleshooting SAN Switching Issues Cisco Fabric Services Send document comments to [email protected]. Step 4 Step 5 Step 6 Principal switch run time information: Running priority: 128 Interface Role RCF-reject fc2/2 Isolated Enabled If you have the rcf-reject option enabled, use the interface command and then the no fcdomain rcf-reject vsan command in interface mode. Example: switch(config)# interface fc 2/2 switch(config-if)# no fcdomain rcf-reject vsan 3 switch(config-if)# Use the fcdomain auto-reconfigure vsan command in the EXEC mode on both switches to enable auto-reconfiguration after a Domain Manager restart. Use the fcdomain restart vsan command to restart Domain Manager. This is a disruptive operation and disruptive reconfiguration and can affect data traffic. Cisco Fabric Services This section includes an overview of troubleshooting Cisco Fabric Services (CFS) followed by a description of common problems and their solutions. Overview Begin troubleshooting CFS issues by checking the following: • Verify that CFS is enabled for the same applications on all affected switches. • Verify that CFS distribution is enabled for the same applications on all affected switches. If the CFS Regions feature is in use, verify that the application is in the same region on all the affected switches. • Verify that there are no pending changes for an application and that a CFS commit was issued for any configuration changes in a CFS-enabled application. • Verify that there are no unexpected CFS locked sessions. Clear any unexpected locked sessions. Verifying CFS using CLI To verify CFS using the CLI, follow these steps: Step 1 By default, CFS distribution is enabled. Applications can distribute data and configuration information to all CFS-capable switches in the fabric where the applications exist. This is the normal mode of operation. To determine the state of CFS distribution on a switch, enter the show cfs status command. Example: OL-25300-01 Cisco Nexus 5000 Series Troubleshooting Guide 5-31