Compaq 315eu Maintenance and Service Guide - Compaq 100eu Small Form Factor, 1 - Page 18
Computer Setup—Power, Table 2-3 - specifications
View all Compaq 315eu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Computer Setup-Power NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 2-3 Computer Setup-Power Option Description After AC Power Failure Allows you to select system restart behavior after power loss: ● Stay Off - keeps power off until the power button is pressed. ● Power On - restores power as soon as power is applied. ● Auto - restarts the computer if it was on before power failure; stays off if the computer was not on. S5 Maximum Power Savings Disables/enables S5 Maximum Power Savings. Enabling this feature reduces the power of this system as much as possible in the S5 state. This feature must be disabled if you want to enable Wake on LAN from S5. WOL in S5 Disables/enables limited Wake on LAN from S5. Note that the computer can only wake from S5 during a normal shutdown event. The S5 Maximum Power Savings feature must be disabled in order to enable limited Wake on LAN from S5. NX (No Execute) Allows you to disable/enable the processor's NX feature. Virtualization Technology Allows you to enable/disable the processor's Virtualization Technology feature. Computer Setup-Boot NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 2-4 Computer Setup-Boot Option Description Boot-time Disables/enables POST diagnostic messages display during boot. Diagnostic Screen Boot Device Priority Allows you to specify which device groups will boot first, second, third, and fourth or to disable any of the four. Also allows you to set the device boot priority within each group. 1st Boot Device 2nd Boot Device 3rd Boot Device 4th Boot Device Allows you to set the device group boot priority: ● CD-ROM Group ● HDD Group ● Floppy Group ● Network Boot Group NOTE: MS-DOS drive lettering assignments may not apply after a non-MSDOS operating system has started. 8 Chapter 2 Computer Setup (F10) Utility