Compaq 315eu Maintenance and Service Guide - Compaq 100eu Small Form Factor, 1 - Page 81
Preparation for Disassembly, on Access Panel, the computer.
View all Compaq 315eu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Table 6-4 Power supply cable connections (continued) P3 Hard drive P4 Optical drive 1. Prepare the computer for disassembly (Preparation for Disassembly on page 43). 2. Remove the access panel (Access Panel on page 44). 3. Lay the computer on its side with the rear facing toward you. 4. Disconnect all power cables from the mass storage devices and from the system board (two connectors). 5. Remove the four screws that secure the power supply to the chassis. 6. Inside of the unit, press the power supply release latch on the chassis base, and then lift up the rear of the power supply to disengage it from the chassis. 7. Slide the power supply toward the front/bottom of the computer, then lift the power supply out of the computer. To install the power supply, reverse the removal procedure. Power Supply 71