Compaq Pro 6300 Maintenance & Service Guide Elite 8300 Touch All-in-One Bu - Page 103
System board, Remove the memory modules see
View all Compaq Pro 6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
System board The system board is located on the right side of the computer (viewed from the rear). It is secured with eight Torx screws. To remove the system board: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the access panel (see Access panel on page 45). 3. Remove the stand (see Stand on page 48). 4. Remove the lower panel (see Lower panel on page 50). 5. Remove the memory modules (see Memory on page 60). 6. Remove the graphics heat sink (see Graphics heat sink on page 75). 7. Remove the processor heat sink (see Processor heat sink - model 6300 on page 76). 8. Remove the processor (see Processor on page 79). 9. Remove the WLAN module (see mSATA Solid-State Drive on page 80). 10. Disconnect all cables from the system board, noting their location for reinstallation. System board 93