Compaq Pro 6300 Maintenance & Service Guide Elite 8300 Touch All-in-One Bu - Page 85
Heat sinks – Graphics board and processor, Graphics heat sink,
View all Compaq Pro 6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Heat sinks - Graphics board and processor Separate heat sinks cool the discrete graphic board (select models only) and the processor. If installed, you must remove the smaller graphics heat sink before you can remove the larger processor heat sink. The graphics heat sink is secured with three Torx screws - two captured, one not captured. The heat sinks share the one non-captured screw. The processor heat sink is secured with five Torx screws - four captured, one shared, not captured. Model 8300 may include a fan attached to the heat sink. Figure 7-44 Heat sink locations Graphics heat sink To remove the heat sink: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the center access panel (see Access panel on page 45). 3. Remove the black Torx screw from the top of the heat sink (1). Heat sinks - Graphics board and processor 75