Compaq Pro 6300 Maintenance & Service Guide Elite 8300 Touch All-in-One Bu - Page 83
Touch sensor board, Remove the access panel see
View all Compaq Pro 6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Touch sensor board NOTE: The touch sensor board is located on the right side of the computer (viewed from behind) above the system board. It is secured with one Torx screw and has three connectors. Touch sensor boards are spared with the touch panel spare part kit. Be sure to replace the touch sensor board when replacing a touch display panel. Figure 7-42 Touch sensor board location To remove the touch sensor board: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the access panel (see Access panel on page 45). 3. Disconnect the cables from the three connectors on the board (1). NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not pull on the wires or cables. Touch sensor board 73