Compaq Pro 6300 Maintenance & Service Guide Elite 8300 Touch All-in-One Bu - Page 86
Processor heat sink – model 6300, CAUTION,
View all Compaq Pro 6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
4. Loosen the two silver captive Torx screws on the heat sink (2), and then lift the heat sink out of the computer (3). CAUTION: Remove heat sink retaining screws in diagonally opposite pairs (as in an X) to even the downward forces on the processor. This is especially important as the pins on the socket are very fragile and any damage to them may require replacing the system board. CAUTION: To reduce a degradation in thermal performance, be sure not to touch the thermal grease on the surface of the processor or the heat sink. Figure 7-45 Removing the graphics heat sink To replace the heat sink, reverse the removal procedures. Processor heat sink - model 6300 To remove the heat sink: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the center access panel (see Access panel on page 45). 3. If installed, remove the graphics heat sink (see Graphics heat sink on page 75). 76 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis