Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 1049

Command Example: priority in Interface VRRP mode FTOS(conf-if-gi-1/2)#vrrp-group 111 FTOS(conf-if-gi-1/2-vrid-111)#priority 125 Command Example Display: show vrrp FTOS#show vrrp GigabitEthernet 1/1, VRID: 111, Net: 10.10.10.1 State: Master, Priority: 255, Master: 10.10.10.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 2343, Gratuitous ARP sent: 5 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.10.1 10.10.10.2 10.10.10.3 10.10.10.10 Authentication: (none GigabitEthernet 1/2, VRID: 111, Net: 10.10.2.1 State: Master, Priority: 125, Master: 10.10.2.1 (local) Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 601, Gratuitous ARP sent: 2 Virtual MAC address: 00:00:5e:00:01:6f Virtual IP address: 10.10.2.2 10.10.2.3 Authentication: (none) FTOS(conf)# Configure VRRP Authentication Note: Authentication is not available for IPv6 VRRP. Simple authentication of VRRP packets ensures that only trusted routers participate in VRRP processes. When authentication is enabled, FTOS includes the password in its VRRP transmission, and the receiving router uses that password to verify the transmission. Note: All virtual routers in the VRRP group must be configured the same: authentication must be enabled with the same password or authentication is disabled. Configure simple authentication with the following command in VRRP configuration mode: Task Configure a simple text password. Command Syntax authentication-type simple [encryption-type] password encryption-type: 0 indicates an unencrypted password in the configuration; 7 indicates an encrypted password in the configuration. password: plain text Command Mode INTERFACE-VRID Virtual Router Redundancy Protocol (VRRP) | 1049