Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 429

Configure the minimum oper up links in a port channel (LAG) You can configure the minimum links in a port channel (LAG) that must be in "oper up" status for the port channel to be considered to be in "oper up" status. Use the following command in the INTERFACE mode: Command Syntax minimum-links number Command Mode INTERFACE Purpose Enter the number of links in a LAG that must be in "oper up" status. Default: 1 The following example displays an example of configuring five minimum "oper up" links in a port channel. FTOS#config t FTOS(conf)#int po 1 FTOS(conf-if-po-1)#minimum-links 5 FTOS(conf-if-po-1)# Add or remove a port channel from a VLAN As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a VLAN, you must place the port channel in Layer 2 mode (by using the switchport command). To add a port channel to a VLAN, use either of the following commands: Command Syntax Command Mode Purpose tagged port-channel id number INTERFACE VLAN Add the port channel to the VLAN as a tagged interface. An interface with tagging enabled can belong to multiple VLANs. untagged port-channel id number INTERFACE VLAN Add the port channel to the VLAN as an untagged interface. An interface without tagging enabled can belong to only one VLAN. To remove a port channel from a VLAN, use either of the following commands: Command Syntax no tagged port-channel id number Command Mode INTERFACE VLAN no untagged port-channel id number INTERFACE VLAN Purpose Remove the port channel with tagging enabled from the VLAN. Remove the port channel without tagging enabled from the VLAN. To see which port channels are members of VLANs, enter the show vlan command in the EXEC Privilege mode. Interfaces | 429