Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 38

www.dell.com | support.dell.com Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. Table 4-1, "FTOS Command Modes," in Configuration Fundamentals lists the CLI mode, its prompt, and information on how to access and exit this CLI mode. You must move linearly through the command modes, with the exception of the end command which takes you directly to EXEC Privilege mode; the exit command moves you up one command mode level. Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to identify the mode and slot/port information. These are shown in Table 4-1, "FTOS Command Modes," in Configuration Fundamentals. Table 4-1. FTOS Command Modes CLI Command Mode EXEC EXEC Privilege CONFIGURATION Prompt FTOS> FTOS# FTOS(conf)# Access Command Access the router through the console or Telnet. • From EXEC mode, enter the command enable. • From any other mode, use the command end. • From EXEC privilege mode, enter the command configure. • From every mode except EXEC and EXEC Privilege, enter the command exit. Note: Access all of the following modes from CONFIGURATION mode. INTERFACE modes ARCHIVE AS-PATH ACL Gigabit Ethernet Interface 10 Gigabit Ethernet Interface Interface Range Loopback Interface Management Ethernet Interface Null Interface Port-channel Interface SONET Interface VLAN Interface FTOS(conf-archive) FTOS(config-as-path)# FTOS(conf-if-gi-0/0)# FTOS(conf-if-te-0/0)# FTOS(conf-if-range)# FTOS(conf-if-lo-0)# FTOS(conf-if-ma-0/0)# FTOS(conf-if-nu-0)# FTOS(conf-if-po-0)# FTOS(conf-if-so-0/0)# FTOS(conf-if-vl-0)# archive ip as-path access-list interface 38 | Configuration Fundamentals