Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 116

www.dell.com | support.dell.com Forcibly Authorizing or Unauthorizing a Port IEEE 802.1X requires that a port can be manually placed into any of three states: • ForceAuthorized is an authorized state. A device connected to this port in this state is never subjected to the authentication process, but is allowed to communicate on the network. Placing the port in this state is same as disabling 802.1X on the port. • ForceUnauthorized an unauthorized state. A device connected to a port in this state is never subjected to the authentication process and is not allowed to communicate on the network. Placing the port in this state is the same as shutting down the port. Any attempt by the supplicant to initiate authentication is ignored. Note: On the C-Series, traffic may continue to be transmitted after an 802.1x-enabled port is configured as force-unauthorized. • Auto is an unauthorized state by default. A device connected to this port is this state is subjected to the authentication process. If the process is successful, the port is authorized and the connected device can communicate on the network. All ports are placed in the auto state by default. To place a port in one of these three states: Step 1 Task Place a port in the ForceAuthorized, ForceUnauthorized, or Auto state. Command Syntax dot1x port-control {force-authorized | force-unauthorized | auto} Default: auto Command Mode INTERFACE The following example shows configuration information for a port that has been force-authorized. FTOS(conf-if-gi-2/1)#dot1x port-control force-authorized FTOS(conf-if-gi-2/1)#do show dot1x interface gigabitethernet 2/1 802.1x information on Gi 2/1: Dot1x Status: Enable Port Control: FORCE_AUTHORIZED Port Auth Status: UNAUTHORIZED Re-Authentication: Disable Untagged VLAN id: None Tx Period: 90 seconds Quiet Period: 120 seconds ReAuth Max: 2 Supplicant Timeout: 30 seconds Server Timeout: 30 seconds Re-Auth Interval: 3600 seconds Max-EAP-Req: 10 Auth Type: SINGLE_HOST Auth PAE State: Initialize Backend State: Initialize Auth PAE State: Initialize Backend State: Initialize 116 | 802.1X