Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 147

FTOS(config-ext-nacl)#end FTOS#show ip accounting access-list ! Extended Ingress IP access list abcd on gigethernet 0/0 seq 5 permit tcp any any seq 10 deny icmp any any permit 1.1.1.2 Configuring Egress ACLs e Layer 2 and Layer 3 ACLs are supported on platform Egress ACLs are applied to line cards and affect the traffic leaving the system. Configuring egress ACLs onto physical interfaces protects the system infrastructure from attack-malicious and incidental-by explicitly allowing only authorized traffic.These system-wide ACLs eliminate the need to apply ACLs onto each interface and achieves the same results. By localizing target traffic, it is a simpler implementation. An egress ACL is used when users would like to restrict egress traffic. For example, when a DOS attack traffic is isolated to one particular interface, you can apply an egress ACL to block that particular flow from exiting the box, thereby protecting downstream devices. To create an egress ACLs, use the ip access-group command in the EXEC Privilege mode. This example also shows viewing the configuration, applying rules to the newly created access group, and viewing the access list: FTOS(conf)#interface gige 0/0 FTOS(conf-if-gige0/0)#ip access-group abcd out FTOS(conf-if-gige0/0)#show config ! gigethernet 0/0 no ip address ip access-group abcd out no shutdown FTOS(conf-if-gige0/0)#end FTOS#configure terminal FTOS(conf)#ip access-list extended abcd FTOS(config-ext-nacl)#permit tcp any any FTOS(config-ext-nacl)#deny icmp any any FTOS(config-ext-nacl)#permit 1.1.1.2 FTOS(config-ext-nacl)#end FTOS#show ip accounting access-list ! Extended Ingress IP access list abcd on gigethernet 0/0 seq 5 permit tcp any any seq 10 deny icmp any any permit 1.1.1.2 IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 147