Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 825

To control the source of RIP route information, use the following commands, in the ROUTER RIP mode: Command Syntax Command Mode Purpose neighbor ip-address ROUTER RIP Define a specific router to exchange RIP information between it and the Dell Force10 system. You can use this command multiple times to exchange RIP information with as many RIP networks as you want. passive-interface interface ROUTER RIP Disable a specific interface from sending or receiving RIP routing information. Another method of controlling RIP (or any routing protocol) routing information is to filter the information through a prefix list. A prefix lists is applied to incoming or outgoing routes. Those routes must meet the conditions of the prefix list; if not, FTOS drops the route. Prefix lists are globally applied on all interfaces running RIP. Configure the prefix list in the PREFIX LIST mode prior to assigning it to the RIP process. For configuration information on prefix lists, refer to Chapter 17, IP Access Control Lists, Prefix Lists, and Route-maps, on page 47. To apply prefix lists to incoming or outgoing RIP routes, use the following commands in the ROUTER RIP mode: Command Syntax distribute-list prefix-list-name in distribute-list prefix-list-name out Command Mode Purpose ROUTER RIP ROUTER RIP Assign a configured prefix list to all incoming RIP routes. Assign a configured prefix list to all outgoing RIP routes. In addition to filtering routes, you can add routes from other routing instances or protocols to the RIP process. With the redistribute command syntax, you can include OSPF, static, or directly connected routes in the RIP process. To add routes from other routing instances or protocols, use any of the following commands in the ROUTER RIP mode: Command Syntax Command Mode Purpose redistribute {connected | static} [metric metric-value] [route-map map-name] ROUTER RIP Include directly connected or user-configured (static) routes in RIP. • metric range: 0 to 16 • map-name: name of a configured route map. redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value] [route-map map-name] ROUTER RIP Include IS-IS routes in RIP. • metric range: 0 to 16 • map-name: name of a configured route map. Note: IS-IS is not supported on the S-Series platform. Routing Information Protocol | 825