Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 435

Note: When creating an interface range, interfaces appear in the order they were entered and are not sorted. The show range command is available under interface range mode. This command allows you to display all interfaces that have been validated under the interface range context. The show configuration command is also available under the interface range mode. This command allows you to display the running configuration only for interfaces that are part of interface range. Bulk Configuration Examples The following are examples of using the interface range command for bulk configuration: • Create a single-range • Create a multiple-range • Exclude duplicate entries • Exclude a smaller port range • Overlap port ranges • Commas • Add ranges Create a single-range FTOS(config)# interface range gigabitethernet 5/1 - 23 FTOS(config-if-range-gi-5/1-23)# no shutdown FTOS(config-if-range-gi-5/1-23)# Create a multiple-range FTOS(conf)#interface range tengigabitethernet 3/0, gigabitethernet 2/1 - 47, vlan 1000 FTOS(conf-if-range-gi-2/1-47,so-5/0)# Exclude duplicate entries Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt: FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3 FTOS(conf-if-range-vl-1,vl-3)# FTOS(conf)#interface range gigabitethernet 2/0 - 23, gigabitethernet 2/0 - 23, gigab 2/0 - 23 FTOS(conf-if-range-gi-2/0-23)# Exclude a smaller port range If interface range has multiple port ranges, the smaller port range is excluded from prompt: FTOS(conf)#interface range gigabitethernet 2/0 - 23 , gigab 2/1 - 10 FTOS(conf-if-range-gi-2/0-23)# Interfaces | 435