Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 680

www.dell.com | support.dell.com Command Syntax ip ospf message-digest-key keyid md5 key ip ospf priority number ip ospf retransmit-interval seconds ip ospf transmit-delay seconds Command Mode Usage CONFIG-INTERFACE Use the MD5 algorithm to produce a message digest or key, which is sent instead of the key. Keyid range: 1 to 255 Key: a character string Be sure to write down or otherwise record the Key. You cannot learn the key once it is configured. You must be careful when changing this key. CONFIG-INTERFACE Change the priority of the interface, which is used to determine the Designated Router for the OSPF broadcast network. Number range: 0 to 255 (the default is 1). CONFIG-INTERFACE Change the retransmission interval between LSAs. Seconds range: from 1 to 65535 (default is 5 seconds). The retransmit interval must be the same on all routers in the OSPF network. CONFIG-INTERFACE Change the wait period between link state update packets sent out the interface. Seconds range: from 1 to 65535 (default is 1 second). The transmit delay must be the same on all routers in the OSPF network. Use the show config command in CONFIGURATION INTERFACE mode to view interface configurations. Use the show ip ospf interface command in EXEC mode to view interface status in the OSPF process. FTOS(conf-if)#ip ospf cost 45 FTOS(conf-if)#show config ! interface GigabitEthernet 0/0 ip address 10.1.2.100 255.255.255.0 no shutdown ip ospf cost 45 FTOS(conf-if)#end FTOS#show ip ospf 34 interface GigabitEthernet 0/0 is up, line protocol is up Internet Address 10.1.2.100/24, Area 2.2.2.2 Process ID 34, Router ID 10.1.2.100, Network Type BROADCAST, Cost: 45 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 10.1.2.100, Interface address 10.1.2.100 Backup Designated Router (ID) 10.1.2.100, Interface address 0.0.0.0 Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:06 Neighbor Count is 0, Adjacent neighbor count is 0 FTOS# 680 | Open Shortest Path First (OSPFv2 and OSPFv3)