Dell Force10 E1200i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 338

www.dell.com | support.dell.com Step Command Syntax 5 member-vlan vlan-id {range} Command Mode CONFIG-FRRP 6 no disable CONFIG-FRRP Set FRRP Timers Purpose Identify the Member VLANs for this FRRP group VLAN-ID, Range: VLAN IDs for the ring's Member VLANs. Enable this FRRP group on this switch. Step Command Syntax Command Mode Purpose 1 timer CONFIG-FRRP Enter the desired intervals for Hello-Interval or {hello-interval|dead-interval} Dead-Interval times. milliseconds Hello-Interval: 50-2000, in increments of 50 (default is 500) Dead-Interval: 50-6000, in increments of 50 (default is 1500) The Dead-Interval time should be set at 3x the Hello-Interval. Clear FRRP counters Use one of the following commands to clear the FRRP counters. Command Syntax clear frrp ring-id clear frrp Command Mode Purpose EXEC PRIVELEGED Clear the counters associated with this Ring ID Ring ID: 1-255 EXEC PRIVELEGED Clear the counters associated with all FRRP groups Show FRRP configuration Use the following command to view the configuration for the FRRP group. Command Syntax show configuration Command Mode CONFIG-FRRP Purpose Show the configuration for this FRRP group Show FRRP information Use one of the following commands show general FRRP information. Command Syntax Command Mode show frrp ring-id EXEC or EXEC PRIVELEGED Purpose Show the information for the identified FRRP group. Ring ID: 1-255 338 | Force10 Resilient Ring Protocol