Dell Inspiron Zino HD 400 Inspiron Zino HD Service Manual - Page 34

Back to Contents Page Power-Button Bracket Dell™ Inspiron™ 300/400 Service Manual Removing the Power-Button Bracket Replacing the Power-Button Bracket WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer). Removing the Power-Button Bracket 1. Follow the procedures in Before You Begin. 2. Remove the top cover (see Removing the Top Cover). 3. Remove the top bracket (see Removing the Top Bracket). 4. Remove the optical drive (see Removing the Optical Drive). 5. Remove the screw that secures the power-button bracket to the drive bay. 1 screw 2 power-button bracket 6. Remove the drive bay (see Removing the Drive Bay). 7. Disconnect the power-button cable from the connector on the system board. 8. Lift the power-button bracket along with the power-button cable away from the computer. Replacing the Power-Button Bracket 1. Follow the procedures in Before You Begin. 2. Connect the power-button cable to the connector on the system board. 3. Replace the drive bay (see Replacing the Drive Bay). 4. Replace the screw that secures the power-button bracket to the drive bay.