Dell PowerEdge 1855 Avocent Digital Access KVM Module Installation Informati - Page 16
following example, 192.168.0.120 is the DRAC/MC default static IP address, 255.255.255.0 is - reset chassis
View all Dell PowerEdge 1855 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
www.dell.com | support.dell.com 9 To set the DRAC/MC time, type: racadm setractime -d yyyymmddhhmmss.mmmmmmsoff where: - yyyy is a 4-digit year - mm is the month - dd is the day - hh is the hour (24-hour clock) - mm is the minute - ss is the second - mmmmmm is the number of microseconds -s is a "+" or "-", indicating the sign of the offset -off is the offset in minutes For example, Monday, May 25, 2004, at 1:30:15 PM EST would be represented as: racadm setractime -d 20040525133015.000000-300 10 If required, assign a static IP address using the following DRAC/MC CLI command: racadm setniccfg -s [ ] The specific address information must be obtained from your network administrator. In the following example, 192.168.0.120 is the DRAC/MC default static IP address, 255.255.255.0 is the subnet mask address, and 192.168.1.1 is the gateway address. racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.1.1 11 Press . 12 Type racadm getniccfg and press . The current and static IP addresses are displayed. 13 If desired, enable Telnet access to the DRAC/MC using the following DRAC/MC CLI command: racadm config -g cfgSerial -o cfgSerialTelnetEnable 1 NOTE: See "Enabling and Configuring the DRAC/MC to Use a Serial or Telnet Console" for additional information. 14 Type racreset and press to reset the controller. 15 Redirect the DRAC/MC serial console to the Ethernet switch module internal serial console interface by entering the following command: connect switch-n where n is the system chassis I/O module bay number in which the Ethernet switch module is installed. NOTE: To switch back to the context of the DRAC/MC CLI command prompt, press . 14 General System Configuration