Dell PowerEdge M420 8/4 Gbps FC SAN Module Administrator's Guide - Page 68

B portCfgShow Notes Operands Examples FC Fastwrite Rate Limit Credit Recovery Port Auto Disable F_Port Buffers Displays ON when FC Fastwrite is enabled on the port or (..) or OFF when disabled. Fastwrite is disabled by default. This value is set by the portCfg fastwrite command. Displays ON when ingress rate limit is set on the port or (..) or OFF when the ingress rate limiting feature is disabled. This value is set by the portCfgQos --setratelimit command. The default value is OFF. Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF when the feature is disabled. This value is set by the portCfgCreditRecovery command. The credit recovery feature is enabled by default, but only ports configured as long distance ports can utilize this feature. Displays On when the Auto Disable feature is enabled on a port. Displays (..) or OFF when the feature is disabled. This feature causes ports to become disabled when they encounter an event that would cause them to reinitialize. This feature is enabled by the portCfgAutoDisable command. The feature is disabled by default. Displays the number of configured internal port (F_Port) buffers. Displays (..) or OFF if no buffers are configured. The buffer value is set by the portCfgfPortbuffers command. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to "Understanding Virtual Fabric restrictions" on page 32 snf "Understanding Admin Domain restrictions" on page 33 for details. This command supports the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be displayed, relative to its slot for bladed systems. Use portCfgshow with one of the following options and optional arguments to display specific FCIP-related parameters configured for a GbE port: To display the configuration settings for a single port on a switch with NPIV mode enabled: switch:admin> portcfgshow 8 Area Number: Speed Level: Fill Word: Trunk Port Locked N_Port Persistent Disable NPIV capability QOS Port Port Auto Disable: Rate Limit F_Port Buffers 8 AUTO(HW) 0(Idle-Idle) ON OFF OFF ON AE OFF OFF OFF To display the configuration settings for all ports on a switch with NPIV Mode enabled: Ports of Slot 0 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Speed AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN Fill Word 0000 0000 0000 0000 54 Dell 8/4Gbps FC SAN Module Administrator's Guide 53-1001345-01