Dell PowerEdge M420 8/4 Gbps FC SAN Module Administrator's Guide - Page 78
information. If a, On bladed systems only, specifies a slot number, followed by a slash /.
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
B supportShow Notes Operands Examples iscsi fcip ag dce_hsl crypto iSCSI group commands, disabled by default. FCIP group commands, disabled by default. Access Gateway group commands, disabled by default. DCE group commands, enabled by default. Encryption group commands, disabled by default. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to "Understanding Virtual Fabric restrictions" on page 32 and "Understanding Admin Domain restrictions" on page 33 for details. This is a diagnostic command and should only be run for diagnostic support. Output generated by this command may vary by switch configuration and platform. Output may change without notice. This command has the following operands: slotnumber On bladed systems only, specifies a slot number, followed by a slash (/). portnumber1-portnumber2 Specifies the range of ports for which to display supportShow information. If a port range is not specified, the command displays information for all ports. lines Specifies the number of lines for the portLogDump output. This parameter is valid only with the slotnumber/portnumber parameters. To display debugging information: switch:admin> supportshow VF Date: Wed Oct 22 09:31:41 UTC 2008 Time Zone: Time Zone Hour Offset: 0 Time Zone Minute Offset: 0 Version: Kernel: Fabric OS: Made on: Flash: BootProm: 2.6.14.2 v6.2.0_main_bld26 Mon Oct 20 10:10:30 2008 Mon Oct 20 16:04:18 2008 1.0.6 supportshow groups enabled: os enabled exception enabled port enabled fabric enabled services enabled security enabled network enabled portlog enabled system enabled extend disabled filter disabled 64 Dell 8/4Gbps FC SAN Module Administrator's Guide 53-1001345-01