Dell PowerEdge T40 EMC Installation and Service Manual - Page 19
PPI Bypass for Enable Commands, Memory Map IO above 4 GB
![]() |
View all Dell PowerEdge T40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Option Memory Map IO above 4 GB Audio Miscellaneous devices Description • Rear Port 3 (Left)* • Rear Port 4 (Center Left)* • Rear Port 5 (Center Right)* • Rear Port 6 (Right)* *Denotes a USB 3.1 Gen 1-capable port Allows you to enable or disable memory mapping IO above 4 GB. The option is enabled by Default setting. Allows you enable or disable the audio feature. • Enable Audio(Default setting) • Enable Internal Speaker (Default setting) Allows you to enable or disable various on-board devices. • Enable PCI Slot (Default setting) Table 4. Video Option Primary Display Description Allows you to configure primary video controller when there are multiple controllers available. • Auto (Default setting) • Intel HD Graphics Table 5. Security Option Admin Password System Password Strong Password Password Configuration Password Bypass Description This option allows you to enable or disable admin passwords for the system (Default setting: not enabled). This option allows you to enable or disable system passwords for the system (Default setting: not enabled). This option allows you to enable or disable strong passwords for the system (Default setting: not enabled). Allows you to control the minimum and maximum number of characters allowed for a administrative password and the system password. The range of characters is between 4 and 32. This option lets you bypass the system (Boot) password and the internal HDD password prompts during a system restart. • Disabled - Always prompt for the system and internal HDD password when they are set. This option is enabled by Default setting. • Reboot Bypass - Bypass the password prompts on Restarts (warm boots). NOTE: The system will always prompt for the system and internal HDD passwords when powered on from the off state (a cold boot). Also, the system will always prompt for passwords on any module bay HDDs that may be present. Password Change This option allows you to determine whether changes to the System and Hard Disk passwords are permitted when an administrator password is set. Allow Non-Admin Password Changes - This option is enabled by Default setting. TPM 2.0 Security Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating NOTE: TPM function is not system. applied to China and Russia. • TPM On (Default setting) • Clear • PPI Bypass for Enable Commands (Default setting) • PPI Bypass for Disable Commands Pre-operating system management applications 19
![](/manual_guide/products/dell-poweredge-t40-emc-installation-service-manual-3780a21/19.png)