Dell PowerEdge T40 EMC Installation and Service Manual - Page 43

Power supply unit, Removing the power supply unit

Get Dell PowerEdge T40 PDF manuals and user guides View all Dell PowerEdge T40 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Figure 19. Closing the PSU assembly Next steps 1. Follow the procedure that is listed in After working inside your system. Power supply unit Removing the power supply unit Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Disconnect the PSU cable from the drive. 4. Open the PSU assembly. 5. Disconnect the PSU cables from the optical drive and the system board. NOTE: Observe the routing of the cable as you remove it from the system. 6. Close the PSU assembly. Steps 1. Remove the screws securing the PSU support bracket to the PSU assembly and remove the PSU support bracket from the chassis. 2. Remove the screws securing the PSU to the PSU assembly. a. Slide and remove the PSU from of the chassis. Installing and removing system components 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
Figure 19. Closing the PSU assembly
Next steps
1.
Follow the procedure that is listed in
After working inside your system
.
Power supply unit
Removing the power supply unit
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure that is listed in
Before working inside your system
.
3.
Disconnect the PSU cable from the drive.
4.
Open the PSU assembly
.
5.
Disconnect the PSU cables from the optical drive and the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
6.
Close the PSU assembly
.
Steps
1.
Remove the screws securing the PSU support bracket to the PSU assembly and remove the PSU support bracket from the chassis.
2.
Remove the screws securing the PSU to the PSU assembly.
a.
Slide and remove the PSU from of the chassis.
Installing and removing system components
43