Dell PowerEdge T40 EMC Installation and Service Manual - Page 75
Next steps
View all Dell PowerEdge T40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
3. Route the power button module cable through the routing clips on the chassis. 4. Connect the power button module cable to the connector on the system board. Next steps 1. Install the control panel. 2. Install the optical Drive. 3. Install the front bezel. 4. Close the PSU hinge. 5. Follow the procedure listed in After working inside your system. Installing and removing system components 75
3.
Route the power button module cable through the routing clips on the chassis.
4.
Connect the power button module cable to the connector on the system board.
Next steps
1.
Install the control panel
.
2.
Install the optical Drive
.
3.
Install the front bezel
.
4.
Close the PSU hinge
.
5.
Follow the procedure listed in
After working inside your system
.
Installing and removing system components
75