Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 250
Remote port monitoring on VLT
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
Remote port monitoring on VLT In a network, devices configured with peer VLT nodes are considered as a single device. You can apply remote port monitoring (RPM) on the VLT devices in a network. In a failover case, the monitored traffic reaches the packet analyzer connected to the TOR through the VLT interconnect link. NOTE: • In VLT devices configured with RPM, when the VLT link is down, the monitored packets might drop for some time. The time is equivalent to the VLT failover recovery time (delay restore). • ERPM does not work on VLT devices. RPM on VLT scenarios Consider a simple VLT setup where two VLT devices are connected using VLTi and a top-of-rack (TOR) switch is connected to both the VLT peers using VLT LAGs in a ring topology. In this setup, the following table describes the possible scenarios when RPM is used to mirror traffic. NOTE: The ports that are connected to the VLT domain, but not part of the VLT-LAG, are called orphan ports. Table 2. RPM on VLT scenarios Scenario Mirror an orphan port or VLT LAG or VLTi member port to VLT LAG. The packet analyzer is connected to the TOR switch. Recommendation The following is an example of recommended configuration on the peer VLT device: 1 Create RSPAN VLAN ! interface vlan 100 no shutdown remote-span ! 2 Create an L2 ACL for the RSPAN VLAN - RSPAN session and attach it to VLTi LAG interface. ! mac access-list rspan seq 10 permit any any capture session 10 vlan 100 ! interface ethernet 1/1/1 no shutdown switchport access vlan 1 mac access-group rspan in ! 3 Create a flow based RSPAN session on the peer VLT device to monitor the VLTi LAG interface as source. ! monitor session 10 type rspan-source destination remote-vlan 100 flow-based enable source interface ethernet1/1/1 (ICL lag member) ! Mirror a VLAN with VLTi LAG as member to any orphan port on the The following is an example of recommended configuration on the same VLT device. The packet analyzer is connected to the local VLT VLT device: device through the orphan port. 250 Layer 2