Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 645

Default Command Mode Usage Information Example DCBX advertises PFC, ETS Recommendation, and ETS Configuration TLVs. INTERFACE A DCBX-enabled port advertises all TLVs to DCBX peers by default. If PFC or ETS TLVs are disabled, enter the command to re-enable PFC or ETS TLV advertisements. You can enable multiple TLV options (ets-conf, ets-reco, and pfc) with the same command. OS10(conf-if-eth1/1/2)# dcbx tlv-select ets-conf pfc Supported Releases 10.3.0E or later dcbx version Configures the DCBX version used on a port interface. Syntax Parameters dcbx version {auto | cee | ieee} • auto - Automatically select the DCBX version based on the peer response. • cee - Set the DCBX version to CEE. • ieee - Set the DCBX version to IEEE 802.1Qaz. Default Command Mode Usage Information Example Auto INTERFACE In auto mode, a DCBX-enabled port detects an incompatible DCBX version on a peer device port and automatically reconfigures a compatible version on the local port. The no version of this command disables the DCBX version. OS10(conf-if-eth1/1/2)# dcbx version cee Supported Releases 10.3.0E or later lldp tlv-select dcbxp Enables and disables DCBX on a port interface. Syntax Parameters Default Command Mode Usage Information Example lldp tlv-select dcbxp None Enabled interface level; disabled global level INTERFACE DCBX must be enabled at both the global and interface levels. Enable DCBX globally with the dcbx enable command to activate the exchange of DCBX TLV messages with PFC, ETS, and iSCSI configurations. Use DCBX interface-level commands to configure the TLVs advertised by a DCBX-enabled port, change the DCBX version, or disable DCBX on an interface. The no version of this command disables DCBX on an interface. OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp Supported Releases 10.3.0E or later Converged data center services 645