Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 289
client-to-client, bgp connection-retry-timer, Usage Information, Example, Example Peers
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 289 highlights
Usage Information Configure your system to accept 4-byte formats before entering a 4-byte AS number. All routers in the Confederation must be 4-byte or 2-byte identified routers. You cannot have a mix of 2-byte and 4-byte identified routers. The autonomous system number you configure in this command is visible to the EBGP neighbors. Each autonomous system is fully meshed and contains a few connections to other autonomous systems. The next-hop (MED) and local preference information is preserved throughout the confederation. The system accepts confederation EBGP peers without a LOCAL_PREF attribute. OS10 sends AS_CONFED_SET and accepts AS_CONFED_SET and AS_CONF_SEQ. The no version of this command deletes the confederation configuration. Example (Identifier) OS10(conf-router-bgp-2)# confederation identifier 1 Example (Peers) OS10(conf-router-bgp-2)# confederation peers 2 Supported Releases 10.3.0E or later client-to-client Enables route reflection between clients in a cluster. Syntax client-to-client {reflection} Parameters reflection - Enter to enable reflection of routes allowed in a cluster. Default Enabled Command Mode ROUTER-BGP Usage Information Configure the route reflector to enable route reflection between all clients. You must fully mesh all clients before you disable route reflection. The no version of this command disables route reflection in a cluster. Example OS10(conf-router-bgp-2)# client-to-client reflection Supported Releases 10.2.0E or later bgp connection-retry-timer Configures a peer connection retry timer. Syntax Parameters Default Command Mode Usage Information Example bgp connection-retry-timer seconds seconds - Enter a timer for connection retry in seconds, from 10 to 65535. 60 seconds ROUTER-NEIGHBOR To configure a peer connection retry timer, use this command. The no version of this command resets the value to the default. OS10(conf-router-neighbor)# connection-retry-timer 15 Supported Releases 10.3.0E or later Layer 3 289