Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 54

line (alias) Configures the commands to be executed in a multi-line alias. Syntax line nn command Parameters • nn - Enter the line number (1 to 99). The commands are executed in the order of the line numbers. • command - Enter the command to be executed enclosed in double quotes. Default Command Mode Usage Information Example Not configured ALIAS The no version of this command removes the line number and the corresponding command from the multi-line alias. OS10(config)# alias mTest OS10(config-alias-mTest)# line 1 "interface $1 $2" OS10(config-alias-mTest)# line 2 "no shutdown" OS10(config-alias-mTest)# line 3 "show configuration" Supported Releases 10.4.0E(R1) or later lock Locks the candidate configuration and prevents any configuration changes on any other CLI sessions, either in transaction or nontransaction-based configuration mode. Syntax Parameters Default Command Mode Usage Information Example lock None Not configured EXEC The lock command fails if there are uncommitted changes in the candidate configuration. OS10# lock Supported Releases 10.2.0E or later management route Configures an IPv4/IPv6 static route used by the Management port. Repeat the command to configure multiple management routes. Syntax Parameters management route {ipv4-address/mask | ipv6-address/prefix-length} {forwardingrouter-address | managementethernet} • ipv4-address/mask - Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prefix-length format (/xx). • ipv6-address/prefix-length - Enter an IPv6 address in x:x:x:x::x format with the prefix length in /x format (prefix range is /0 to /128). 54 Getting Started