Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 627
vlt-mac, vrrp mode active-active
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 627 highlights
Parameters Default Command Mode Usage Information Example (peer 1) vlt-lag-id - Enter a VLT port-channel ID, from 1 to 1024. Not configured PORT-CHANNEL INTERFACE Assign the same VLT port-channel ID to interfaces on VLT peers to create a VLT port-channel. The no version of this command removes the VLT port-channel ID configuration. OS10(conf-if-po-10)# vlt-port-channel 1 Example (peer 2) OS10(conf-if-po-20)# vlt-port-channel 1 Supported Releases 10.2.0E or later vlt-mac Configures a MAC address for all peer switches in a VLT domain. Syntax Parameters Default Command Mode Usage Information vlt-mac mac-address mac-address - Enter a MAC address for the topology in nn:nn:nn:nn:nn:nn format. Not configured VLT-DOMAIN Use this command to minimize the time required to synchronize the default MAC address of the VLT domain on both peer devices when one peer switch reboots. If you do not configure a VLT MAC address, the MAC address of the primary peer is used as the VLT MAC address across all peers. This configuration must be symmetrical in all the peer switches to avoid any unpredictable behavior. For example, unit down or VLTi reset. The no version of this command disables the VLT MAC address configuration. NOTE: Configure the VLT MAC address as symmetrical in all the VLT peer switches to avoid any unpredictable behavior when any unit is down or when VLTi is reset. Example OS10(conf-vlt-1)# vlt-mac 00:00:00:00:00:02 Supported Releases 10.2.0E or later vrrp mode active-active Enables the VRRP peers to locally forward L3 traffic in a VLAN interface. Syntax vrrp mode active-active Parameters None Default Enabled Command Mode VLAN INTERFACE Usage Information The no version of this command disables the configuration. This command is applicable only for VLAN interfaces. Example OS10(conf-if-vl-10)# vrrp mode active-active Supported Releases 10.2.0E or later Virtual link trunking 627