Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 438

DHCP commands default-router address Assigns a default gateway to clients based on the IP address pool. Syntax Parameters default-router address [address2...address8] • address - Enter an IPv4 or IPv6 address to use as the default gateway for clients on the subnet in A.B.C.D or A::B format. • address2...address8 - (Optional) Enter up to eight IP addresses, in order of preference. Default Command Mode Usage Information Example Not configured DHCP-POOL Configure up to eight IP addresses, in order of preference. Use the no version of this command to remove the configuration. OS10(conf-dhcp-20.1.1.1)# default-router 20.1.1.100 Supported Releases 10.2.0E or later disable Disables the DHCP server. Syntax Parameters Default Command Mode Usage Information Example disable None Disabled DHCP The no version of this command enables the DHCP server. OS10(conf-dhcp)# no disable Supported Releases 10.2.0E or later dns-server address Assigns a DNS server to clients based on the address pool. Syntax dns-server address [address2...address8] Parameters • address - Enter the DNS server IP address that services clients on the subnet in A.B.C.D or A::B format. • address2...address8 - (Optional) Enter up to eight DNS server addresses, in order of preference. Default Not configured 438 System management