Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 94
View interface configuration
![]() |
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
View interface configuration To view basic interface information, use the show interface, show running-configuration, and show interface status commands. You can stop scrolling output from a show command by entering CTRL+C. Display information about a physical or virtual interface in EXEC mode (including up/down status, MAC and IP addresses, and input/output traffic counters). show interface [type] • phy-eth node/slot/port[:subport] - Display information about physical media connected to the interface. • status - Display interface status. • ethernet node/slot/port[:subport] - Display Ethernet interface information. • loopback id - Display loopback interface information (0 to 16383). • mgmt node/slot/port - Display Management interface information. • port-channel id-number - Display port-channel interface information (1 to 128). • vlan vlan-id - Display the VLAN interface information (1 to 4093). View interface information OS10# show interface Ethernet 1/1/1 is up, line protocol is up Hardware is Dell EMC Eth, address is 00:0c:29:98:1b:79 Current address is 00:0c:29:98:1b:79 Pluggable media present, QSFP-PLUS type is QSFP_40GBASE_CR4_1M Wavelength is 64 SFP receive power reading is 0.0 Interface index is 16866084 Internet address is not set Mode of IPv4 Address Assignment: not set MTU 1532 bytes LineSpeed 40G, Auto-Negotiation on Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 60 Last clearing of "show interface" counters: 3 weeks 1 day 22:48:51 Queuing strategy: fifo Input statistics: 0 packets, 0 octets 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output statistics: 0 packets, 0 octets 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 Collisions, 0 wreddrops Rate Info(interval 299 seconds): Input 0 Mbits/sec, 0 packets/sec, 0% of line rate Output 0 Mbits/sec, 0 packets/sec, 0% of line rate Time since last interface status change: 3 weeks 1 day 20:30:38 --more-- View specific interface information OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# show configuration ! interface ethernet1/1/1 ip address 1.1.1.1/24 no switchport no shutdown 94 Interfaces
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-1040er3-c44ef57/94.png)