Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.0ER - Page 519
permit (MAC), permit icmp
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 519 highlights
Usage Information Example OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# permit udp any any capture session 1 Supported Releases 10.2.0E or later permit (MAC) Configures a filter to allow packets with a specific MAC address. Syntax permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | count [byte] | cos | vlan] Parameters • nn:nn:nn:nn:nn:nn - Enter the MAC address. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set which routes are subject to the filter: - protocol-number - Enter the MAC protocol number identified in the MAC header, from 600 to ffff. - capture - (Optional) Enter the capture packets the filter processes. - count - (Optional) Enter the count packets the filter processes. - byte - (Optional) Enter the count bytes the filter processes. - cos - (Optional) Enter the CoS value, from 0 to 7. - vlan - (Optional) Enter the VLAN number, from 1 to 4093. Default Command Mode Usage Information Example Not configured MAC-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter. OS10(config)# mac access-list macacl OS10(conf-mac-acl)# permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7 OS10(conf-mac-acl)# permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2 Supported Releases 10.2.0E or later permit icmp Configures a filter to permit all or specific internet control message protocol (ICMP) messages. Syntax permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture |count [byte] | dscp value | fragment] Parameters • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. Access Control Lists 519