Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 1084

The VRID range is from 1 to 255. NOTE: The interface must already have a primary IP address defined and be enabled, as shown in the second example. • Delete a VRRP group. INTERFACE mode no vrrp-group vrid Examples of Configuring and Verifying VRRP The following examples how to configure VRRP. DellEMC(conf)#interface tengigabitethernet 1/1 DellEMC(conf-if-te-1/1)#vrrp-group 111 DellEMC(conf-if-te-1/1-vrid-111)# The following examples how to verify the VRRP configuration. DellEMC(conf-if-te-1/1)#show conf ! interface TenGigabitEthernet 1/1 ip address 10.10.10.1/24 ! vrrp-group 111 no shutdown Configuring the VRRP Version for an IPv4 Group For IPv4, you can configure a VRRP group to use one of the following VRRP versions: • VRRPv2 as defined in RFC 3768, Virtual Router Redundancy Protocol (VRRP) • VRRPv3 as defined in RFC 5798, Virtual Router Redundancy Protocol (VRRP) Version 3 for IPv4 and IPv6 You can also migrate a IPv4 group from VRRPv2 to VRRP3. To configure the VRRP version for IPv4, use the version command in INTERFACE mode. Example: Configuring VRRP to Use Version 3 The following example configures the IPv4 VRRP 100 group to use VRRP protocol version 3. DellEMC(conf-if-te-1/1)# vrrp-group 100 DellEMC(conf-if-te-1/1-vrid-100)#version ? 2 VRRPv2 3 VRRPv3 both Interoperable, send VRRPv3 receive both DellEMC(conf-if-te-1/1-vrid-100)#version 3 You can use the version both command in INTERFACE mode to migrate from VRRPv2 to VRRPv3. When you set the VRRP version to both, the switch sends only VRRPv3 advertisements but can receive VRRPv2 or VRRPv3 packets. To migrate an IPv4 VRRP group from VRRPv2 to VRRPv3: 1 Set the switches with the lowest priority to "both". 2 Set the switch with the highest priority to version to 3. 3 Set all the switches from both to version 3. NOTE: Do not run VRRP version 2 and version 3 in the same group for an extended period of time 1084 Virtual Router Redundancy Protocol (VRRP)