Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 134

route-map dilling permit 10 DellEMC(config-route-map)# You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order. Dell EMC Networking OS processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, such as redistribute, traffic passes through all instances of that route map until a match is found. The following is an example with two instances of a route map. The following example shows matching instances of a route-map. DellEMC#show route-map route-map zakho, permit, sequence 10 Match clauses: Set clauses: route-map zakho, permit, sequence 20 Match clauses: interface TenGigabitEthernet 1/1 Set clauses: tag 35 level stub-area DellEMC# To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax. DellEMC(conf)#no route-map zakho 10 DellEMC(conf)#end DellEMC#show route-map route-map zakho, permit, sequence 20 Match clauses: interface TenGigabitEthernet 1/1 Set clauses: tag 35 level stub-area DellEMC# The following example shows a route map with multiple instances. The show config command displays only the configuration of the current route map instance. To view all instances of a specific route map, use the show route-map command. DellEMC#show route-map dilling route-map dilling, permit, sequence 10 Match clauses: Set clauses: route-map dilling, permit, sequence 15 Match clauses: interface Loopback 23 Set clauses: tag 3444 DellEMC# To delete a route map, use the no route-map map-name command in CONFIGURATION mode. Configure Route Map Filters Within ROUTE-MAP mode, there are match and set commands. • match commands search for a certain criterion in the routes. • set commands change the characteristics of routes, either adding something or specifying a level. When there are multiple match commands with the same parameter under one instance of route-map, Dell EMC Networking OS does a match between all of those match commands. If there are multiple match commands with different parameters, Dell EMC Networking OS does a match ONLY if there is a match among ALL the match commands. In the following example, there is a match if a route has any of the tag values specified in the match commands. 134 Access Control Lists (ACLs)