Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 577

Output (S,G) filter: none [Router 1] R1(conf)#do show ip msdp peer Peer Addr: 192.168.0.3 Local Addr: 0.0.0.0(0) Connect Source: Lo 0 State: Inactive Up/Down Time: 00:00:03 Timers: KeepAlive 30 sec, Hold time 75 sec SourceActive packet count (in/out): 0/0 SAs learned from this peer: 0 SA Filtering: Clearing Peer Statistics To clear the peer statistics, use the following command. • Reset the TCP connection to the peer and clear all peer statistics. CONFIGURATION mode clear ip msdp peer peer-address Example of the clear ip msdp peer Command and Verifying Statistics are Cleared R3(conf)#do show ip msdp peer Peer Addr: 192.168.0.1 Local Addr: 192.168.0.3(639) Connect Source: Lo 0 State: Established Up/Down Time: 00:04:26 Timers: KeepAlive 30 sec, Hold time 75 sec SourceActive packet count (in/out): 5/0 SAs learned from this peer: 0 SA Filtering: Input (S,G) filter: myremotefilter Output (S,G) filter: none R3(conf)#do clear ip msdp peer 192.168.0.1 R3(conf)#do show ip msdp peer Peer Addr: 192.168.0.1 Local Addr: 0.0.0.0(0) Connect Source: Lo 0 State: Inactive Up/Down Time: 00:00:04 Timers: KeepAlive 30 sec, Hold time 75 sec SourceActive packet count (in/out): 0/0 SAs learned from this peer: 0 SA Filtering: Input (S,G) filter: myremotefilter Output (S,G) filter: none Debugging MSDP To debug MSDP, use the following command. • Display the information exchanged between peers. CONFIGURATION mode debug ip msdp Example of the debug ip msdp Command R1(conf)#do debug ip msdp All MSDP debugging has been turned on R1(conf)#03:16:08 : MSDP-0: Peer 192.168.0.3, sent Keepalive msg 03:16:09 : MSDP-0: Peer 192.168.0.3, rcvd Keepalive msg 03:16:27 : MSDP-0: Peer 192.168.0.3, sent Source Active msg 03:16:38 : MSDP-0: Peer 192.168.0.3, sent Keepalive msg 03:16:39 : MSDP-0: Peer 192.168.0.3, rcvd Keepalive msg 03:17:09 : MSDP-0: Peer 192.168.0.3, sent Keepalive msg Multicast Source Discovery Protocol (MSDP) 577