Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 707

Decapsulation of ERPM packets at the Destination IP/ Analyzer • In order to achieve the decapsulation of the original payload from the ERPM header. The below two methods are suggested : a Using Network Analyzer - Install any well-known Network Packet Analyzer tool which is open source and free to download. - Start capture of ERPM packets on the Sniffer and save it to the trace file (for example : erpmwithheader.pcap). - The Header that gets attached to the packet is 38 bytes long. In case of a packet with L3 VLAN, it would be 42 bytes long. The original payload /original mirrored data starts from the 39th byte in a given ERPM packet. The first 38/42 bytes of the header needs to be ignored/ chopped off. - Some tools support options to edit the capture file. We can make use of such features (for example: editcap ) and chop the ERPM header part and save it to a new trace file. This new file (i.e. the original mirrored packet) can be converted back into stream and fed to any egress interface. b Using Python script - Either have a Linux server's ethernet port ip as the ERPM destination ip or connect the ingress interface of the server to the ERPM MirrorToPort. The analyzer should listen in the forward/egress interface. If there is only one interface, one can choose the ingress and forward interface to be same and listen in the tx direction of the interface. - Download/ Write a small script (for example: erpm.py) such that it will strip the given ERPM packet starting from the bit where GRE header ends. Basically all the bits after 0x88BE need to be removed from the packet and sent out through another interface. - This script erpm.zip is available for download at the following location: https://en.community.dell.com/techcenter/ networking/m/force10_networking_scripts/20438882.aspx - Unzip the erpm.zip and copy the erpm.py file to the Linux server. - Run the python script using the following command: python erpm.py -i -o erpm.py : This is the script downloaded from the script store. : Specify the interface id which is connected to the mirroring port or this should be interface whose ip address has been specified as the destination ip address in the ERPM session. : Specify another interface on the Linux server via which the decapsulation packets can Egress. In case there is only one interface, the ingress interface itself can be specified as Egress and the analyzer can listen in the tx direction. Port Monitoring on VLT Devices on which VLT is configured are seen as a single device in the network. You can apply port monitoring function on the VLT devices in the network. Port monitoring enables ingress or egress traffic traversing on a port to be sent to another port so that the traffic can be analyzed. The port to which traffic is sent for analysis is called the mirroring port. This port is connect to a port analyzer, which performs the traffic analysis function. Depending up on the location of the port to which the port analyzer is connected, port monitoring is classified into three categories: local Port mirroring, remote port mirroring (RPM), and encapsulated remote port mirroring (ERPM). NOTE: For more information on port monitoring, see Port Monitoring. Port Monitoring 707