Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 269

The internal Priority assigned for the packet by Ingress FP is used by the memory management unit (MMU) to assign the packet to right queue by indexing the internal-priority to queue map table (TABLE 1) in hardware. PRIO2COS setting for honoring the PFC protocol packets from the Peer switches is as per above Packet-Dot1p->queue table (Table 2). The packets come in with packet-dot1p 2 alone are assign to PG6 on ingress. The packets come in with packet-dot1p 2 alone use Q1 (as per dot1p to Queue classification - Table 2) on the egress port. • When Peer sends a PFC message for Priority 2, based on above PRIO2COS table (TABLE 2), Queue 1 is halted. • Queue 1 starts buffering the packets with Dot1p 2. This causes PG6 buffer counter to increase on the ingress, since P-dot1p 2 is mapped to PG6. • As the PG6 watermark threshold is reached, PFC generates for dot1p 2. Configuration Example for DSCP and PFC Priorities Consider a scenario in which the following DSCP and PFC priorities are necessary: DSCP Expected PFC Priority 0 - 5, 10 - 15 20 - 25, 30 - 35 1 2 To configure the aforementioned DSCP and PFC priority values, perform the following tasks: 1 Create class-maps to group the DSCP subsets class-map match-any dscp-pfc-1 match ip dscp 0-5,10-15 ! class-map match-any dscp-pfc-2 match ip dscp 20-25,30-35 2 Associate above class-maps to Queues Queue assignment as below. NOTE: Although, each port on the S4810, S4820T, and S5000 devices support 8 QoS queues, you can configure only 4 QoS queues (0-3)to manage data traffic. The remaining 4 queues (4-7) are reserved for control traffic. Table 18. Queue Assignments Internal- 0 1 2 3 4 5 6 7 priority Queue 0 0 0 1 2 3 3 3 3 Dot1p->Queue Mapping Configuration is retained at the default value. Default dot1p-queue mapping is, DellEMC#show qos dot1p-queue-mapping Dot1p Priority : 0 1 2 3 4 5 6 7 Queue : 0 0 0 1 2 3 3 3 Default dot1p-queue mapping is, DellEMC#show qos dot1p-queue-mapping Dot1p Priority : 0 1 2 3 4 5 6 7 Queue : 2 0 1 3 4 5 6 7 4 Interface Configurations on server connected ports. a Enable DCB globally. DellEMC(conf)#dcb enable Data Center Bridging (DCB) 269