Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 39

PORT-CHANNEL FAILOVER-GROUP PREFIX-LIST PRIORITY-GROUP PROTOCOL GVRP QOS POLICY RSTP ROUTE-MAP ROUTER BGP BGP ADDRESS-FAMILY ROUTER ISIS ISIS ADDRESS-FAMILY ROUTER OSPF ROUTER OSPFV3 ROUTER RIP SPANNING TREE SUPPORTASSIST TRACE-LIST VLT DOMAIN VRRP UPLINK STATE GROUP uBoot Navigating CLI Modes The Dell EMC Networking OS prompt changes to indicate the CLI mode. The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit command which moves you up one command mode level. NOTE: Sub-CONFIGURATION modes all have the letters conf in the prompt with more modifiers to identify the mode and slot/ port information. Table 1. Dell EMC Networking OS Command Modes CLI Command Mode Prompt EXEC DellEMC> EXEC Privilege DellEMC# CONFIGURATION DellEMC(conf)# NOTE: Access all of the following modes from CONFIGURATION mode. AS-PATH ACL 10 Gigabit Ethernet Interface 40 Gigabit Ethernet Interface DellEMC(config-as-path)# DellEMC(conf-if-te-0/0)# DellEMC(conf-if-fo-0/0)# Access Command Access the router through the console or terminal line. • From EXEC mode, enter the enable command. • From any other mode, use the end command. • From EXEC privilege mode, enter the configure command. • From every mode except EXEC and EXEC Privilege, enter the exit command. ip as-path access-list interface (INTERFACE modes) interface (INTERFACE modes) Configuration Fundamentals 39