Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 651

show running-config ospf • View the summary information of the IP routes. EXEC Privilege mode show ip route summary • View the summary information for the OSPF database. EXEC Privilege mode show ip ospf database • View the configuration of OSPF neighbors connected to the local router. EXEC Privilege mode show ip ospf neighbor • View the LSAs currently in the queue. EXEC Privilege mode show ip ospf timers rate-limit • View debug messages. EXEC Privilege mode debug ip ospf process-id [event | packet | spf | database-timers rate-limit] To view debug messages for a specific OSPF process ID, use the debug ip ospf process-id command. If you do not enter a process ID, the command applies to the first OSPF process. To view debug messages for a specific operation, enter one of the optional keywords: - event: view OSPF event messages. - packet: view OSPF packet information. - spf: view SPF information. - database-timers rate-limit: view the LSAs currently in the queue. Example of Viewing OSPF Configuration DellEMC#show run ospf ! router ospf 4 router-id 4.4.4.4 network 4.4.4.0/28 area 1 ! ipv6 router ospf 999 default-information originate always router-id 10.10.10.10 DellEMC# Sample Configurations for OSPFv2 The following configurations are examples for enabling OSPFv2. These examples are not comprehensive directions. They are intended to give you some guidance with typical configurations. You can copy and paste from these examples to your CLI. To support your own IP addresses, interfaces, names, and so on, be sure that you make the necessary changes. Basic OSPFv2 Router Topology The following illustration is a sample basic OSPFv2 topology. Open Shortest Path First (OSPFv2 and OSPFv3) 651