Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 200

Capabilities received from neighbor for IPv4 Unicast : MULTIPROTO_EXT(1) ROUTE_REFRESH(2) CISCO_ROUTE_REFRESH(128) Capabilities advertised to neighbor for IPv4 Unicast : MULTIPROTO_EXT(1) ROUTE_REFRESH(2) CISCO_ROUTE_REFRESH(128) fall-over enabled Update source set to Loopback 0 Peer active in peer-group outbound optimization For address family: IPv4 Unicast BGP table version 52, neighbor version 52 4 accepted prefixes consume 16 bytes Prefix advertised 0, denied 0, withdrawn 0 Connections established 6; dropped 5 Last reset 00:19:37, due to Reset by peer Notification History 'Connection Reset' Sent : 5 Recv: 0 Local host: 200.200.200.200, Local port: 65519 Foreign host: 100.100.100.100, Foreign port: 179 DellEMC# To verify that fast fall-over is enabled on a peer-group, use the show ip bgp peer-group command (shown in bold). DellEMC#sh ip bgp peer-group Peer-group test fall-over enabled BGP version 4 Minimum time between advertisement runs is 5 seconds For address family: IPv4 Unicast BGP neighbor is test Number of peers in this group 1 Peer-group members (* - outbound optimized): 100.100.100.100* DellEMC# router bgp 65517 neighbor test peer-group neighbor test fall-over neighbor test no shutdown neighbor 100.100.100.100 remote-as 65517 neighbor 100.100.100.100 fall-over neighbor 100.100.100.100 update-source Loopback 0 neighbor 100.100.100.100 no shutdown DellEMC# Configuring Passive Peering When you enable a peer-group, the software sends an OPEN message to initiate a TCP connection. If you enable passive peering for the peer group, the software does not send an OPEN message, but it responds to an OPEN message. 200 Border Gateway Protocol version 4 (BGPv4)