Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 536

fefd [mode {aggressive | normal}] • Disable FEFD protocol on one interface. INTERFACE mode fefd disable Disabling an interface shuts down all protocols working on that interface's connected line. It does not delete your previous FEFD configuration which you can enable again at any time. To set up and activate two or more connected interfaces, use the following commands. 1 Setup two or more connected interfaces for Layer 2 or Layer 3. INTERFACE mode ip address ip address, switchport 2 Activate the necessary ports administratively. INTERFACE mode no shutdown 3 INTERFACE mode fefd {disable | interval | mode} Example of Viewing FEFD Configuration DellEMC(conf-if-te-1/1)#show config ! interface TenGigabitEthernet 1/1 no ip address switchport fefd mode normal no shutdown DellEMC(conf-if-te-1/1)#do show fefd | grep 1/1 Te 1/1 Normal 3 Unknown Debugging FEFD To debug FEFD, use the first command. To provide output for each packet transmission over the FEFD enabled connection, use the second command. • Display output whenever events occur that initiate or disrupt an FEFD enabled connection. EXEC Privilege mode debug fefd events • Provide output for each packet transmission over the FEFD enabled connection. EXEC Privilege mode debug fefd packets Examples of the debug fefd Commands DellEMC#debug fefd events DellEMC#config DellEMC(conf)#int te 1/1 DellEMC(conf-if-te-1/1)#shutdown 2w1d22h: %RPM0-P:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Te 1/1 DellEMC(conf-if-te-1/1)#2w1d22h : FEFD state on Te 1/1 changed from ANY to Unknown 2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Te 1/1 2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Te 4/1 536 Layer 2