Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 360

Based on the configuration in the following example, the interface is not removed from VLAN 34 or VLAN 35 despite receiving a GVRP Leave message. Additionally, the interface is not dynamically added to VLAN 45 or VLAN 46, even if a GVRP Join message is received. Example of the gvrp registration Command DellEMC(conf-if-te-1/21)#gvrp registration fixed 34,35 DellEMC(conf-if-te-1/21)#gvrp registration forbidden 45,46 DellEMC(conf-if-te-1/21)#show conf ! interface TenGigabitEthernet 1/21 no ip address switchport gvrp enable gvrp registration fixed 34-35 gvrp registration forbidden 45-46 no shutdown DellEMC(conf-if-te-1/21)# Configure a GARP Timer Set GARP timers to the same values on all devices that are exchanging information using GVRP. There are three GARP timer settings. • Join - A GARP device reliably transmits Join messages to other devices by sending each Join message two times. To define the interval between the two sending operations of each Join message, use this parameter. The Dell EMC Networking OS default is 200ms. • Leave - When a GARP device expects to de-register a piece of attribute information, it sends out a Leave message and starts this timer. If a Join message does not arrive before the timer expires, the information is de-registered. The Leave timer must be greater than or equal to 3x the Join timer. The Dell EMC Networking OS default is 600ms. • LeaveAll - After startup, a GARP device globally starts a LeaveAll timer. After expiration of this interval, it sends out a LeaveAll message so that other GARP devices can re-register all relevant attribute information. The device then restarts the LeaveAll timer to begin a new cycle. The LeaveAll timer must be greater than or equal to 5x of the Leave timer. The Dell EMC Networking OS default is 10000ms. Example of the garp timer Command DellEMC(conf)#garp timer leav 1000 DellEMC(conf)#garp timers leave-all 5000 DellEMC(conf)#garp timer join 300 Verification: DellEMC(conf)#do show garp timer GARP Timers Value (milliseconds) Join Timer 300 Leave Timer 1000 LeaveAll Timer 5000 DellEMC(conf)# Dell EMC Networking OS displays this message if an attempt is made to configure an invalid GARP timer: DellEMC(conf)#garp timers join 300 % Error: Leave timer should be >= 3*Join timer. RPM Redundancy The current version of Dell EMC Networking OS supports 1+1 hitless route processor module (RPM) redundancy. The primary RPM performs all routing, switching, and control operations while the standby RPM monitors the primary RPM. In the event that the primary RPM fails, the standby RPM can assume control of the system without requiring a chassis reboot. This section contains the following sub-sections: • Boot the Chassis with a Single RPM • Boot the Chassis with Dual RPMs 360 GARP VLAN Registration Protocol (GVRP)