Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.14.1.0 - Page 580

4 Peer each RP with every other RP using MSDP, specifying the unique Loopback address as the connect-source. CONFIGURATION mode ip msdp peer 5 Advertise the network of each of the unique Loopback addresses throughout the network. ROUTER OSPF mode network Reducing Source-Active Message Flooding RPs flood source-active messages to all of their peers away from the RP. When multiple RPs exist within a domain, the RPs forward received active source information back to the originating RP, which violates the RFP rule. You can prevent this unnecessary flooding by creating a mesh-group. A mesh in this context is a topology in which each RP in a set of RPs has a peership with all other RPs in the set. When an RP is a member of the mesh group, it forwards active source information only to its peers outside of the group. To create a mesh group, use the following command. • Create a mesh group. CONFIGURATION mode ip msdp mesh-group Specifying the RP Address Used in SA Messages The default originator-id is the address of the RP that created the message. In the case of Anycast RP, there are multiple RPs all with the same address. To use the (unique) address of another interface as the originator-id, use the following command. • Use the address of another interface as the originator-id instead of the RP address. CONFIGURATION mode ip msdp originator-id Examples of R1, R2, and R3 Configuration for MSDP with Anycast RP The following example shows an R1 configuration for MSDP with Anycast RP. ip multicast-routing ! interface TenGigabitEthernet 1/1 ip pim sparse-mode ip address 10.11.3.1/24 no shutdown ! interface TenGigabitEthernet 1/2 ip address 10.11.2.1/24 no shutdown ! interface TenGigabitEthernet 1/21 ip pim sparse-mode ip address 10.11.1.12/24 no shutdown ! interface Loopback 0 ip pim sparse-mode ip address 192.168.0.1/32 no shutdown ! 580 Multicast Source Discovery Protocol (MSDP)