Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1131

Interface statistics Table 75. Interface statistics YANG Container if/interfaces-state/interface/statistics dell-base-if-cmn/if/interfaces-state/interface Port-channel (lag) member ports Minimum sampling interval (milliseconds) 15000 15000 Table 76. Port-channel (lag) member ports YANG Container dell-base-if-cmn/if/interfaces System statistics Minimum sampling interval (milliseconds) 0 Table 77. System statistics YANG Container system-status/current-status Minimum sampling interval (milliseconds) 15000 Configure telemetry NOTE: To set up a streaming telemetry collector, download and use the OS10 telemetry .proto files from the Dell EMC Support site. To enable the streaming of telemetry data to destinations in a subscription profile: 1 Enable telemetry on the switch. 2 Configure a destination group. 3 Configure a subscription profile by associating one or more destination groups and pre-configured sensor groups. After you complete Step 3, the telemetry agent starts streaming data to destination devices. Configuration notes • The telemetry agent collects data from OS10 applications and switch hardware. When you configure a sampling rate of 0, which is near real-time, telemetry collects data as soon as an event occurs. If you configure a sampling rate, telemetry performs periodic data collection. The recommended minimum sampling intervals are described in Configure a sensor group. • OS10 telemetry supports: - Only one configured destination group, and only one destination address in the group. - Only one subscription profile. Enable telemetry 1 Enter telemetry mode from CONFIGURATION mode. OS10(config)# telemetry 2 Enable streaming telemetry in TELEMETRY mode. OS10(conf-telemetry)# enable Configure a sensor group Telemetry 1131