Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 371

NOTE: However, the zero-touch deployment (ZTD) application requires this functionality. While ZTD is in progress, the system assigns an IP address to the default VLAN to establish connectivity. After ZTD is complete, the system removes the IP address assigned to the default VLAN. You can place VLANs and other logical interfaces in L3 mode to receive and send routed traffic. 1 Create a VLAN in CONFIGURATION mode, from 1 to 4093. interface vlan vlan-id 2 Assign an IP address and mask to the VLAN in INTERFACE-VLAN mode. ip address ip-address/prefix-length [secondary] • ip-address/prefix-length - Enter the IP address in dotted-decimal A.B.C.D/x format. • secondary - Enter the interface backup IP address. Assign IP address to VLAN OS10(config)# interface vlan 200 OS10(conf-if-vl-200)# ip address 10.1.15.1/8 View VLAN configuration OS10(conf-if-vl-200)# do show interface vlan Vlan 1 is up, line protocol is up Address is , Current address is Interface index is 69208865 Internet address is not set MTU 1532 bytes LineSpeed auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 240 Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface status change: Vlan 200 is up, line protocol is up Address is , Current address is Interface index is 69209064 Internet address is not set MTU 1532 bytes LineSpeed auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 240 Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface status change: Vlan 320 is up, line protocol is up Address is , Current address is Interface index is 69209184 Internet address is 20.2.11.1/24 MTU 1532 bytes LineSpeed auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 240 Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface status change: View VLAN configuration You can view configuration information related to VLANs using show commands. • View the VLAN status and configuration information in EXEC mode. show vlan Layer 2 371