Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 283

lacp fallback timeout Configures LACP fallback time out period. Syntax Parameters Default Command Mode Usage Information Example lacp fallback timeout timer-value timer-value-Enter the timer values in seconds, ranging from 0 to 100 seconds. 15 seconds Port-channel INTERFACE The no version of this command returns the timer to default value. OS10# configure terminal OS10(config)# interface port-channel 1 OS10(conf-if-po-1)# lacp fallback timeout 20 Supported Releases 10.3.2E(R3) or later lacp max-bundle Configures the maximum number of active members allowed in a port-channel. Syntax lacp max-bundle max-bundle-number Parameters max-bundle-number - Enter the maximum bundle size (1 to 32). Default 32 Command Mode INTERFACE Usage Information The no version of this command resets the maximum bundle size to the default value. Example OS10(conf-if-po-10)# lacp max-bundle 10 Supported Releases 10.2.0E or later lacp port-priority Sets the priority for the physical interfaces for LACP. Syntax lacp port-priority priority Parameters priority - Enter the priority for the physical interfaces (0 to 65535). Default 32768 Command Mode INTERFACE Usage Information LACP uses the port priority with the port number to create the port identifier. The port priority decides which ports are put into Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, or when you have more than eight ports configured for the channel group. When setting the priority, a higher number means a lower priority. The no version of this command returns the port priority to the default value. Example OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 32768 Layer 2 283