Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 388

Application VLT backup link VRRP Management VRF Yes Yes Default VRF Yes Yes Non-default VRF No Yes Configure a static route for a management VRF instance • Configure a static route that directs traffic to the management interface. CONFIGURATION management route ip-address mask managementethernet or management route ipv6-address prefixlength managementethernet You can also configure the management route to direct traffic to a physical interface. For example: management route 10.1.1.5/24 ethernet 1/1/4 or management route 2::/64 ethernet 1/1/2. • Configure a static entry in the IPv6 neighbor discovery. CONFIGURATION ipv6 neighbor vrf management 1::1 ethernet 1/1/2 xx:xx:xx:xx:xx:xx Configure non-default VRF instances In addition to a management VRF instance and default VRF, OS10 also supports non-default VRF instances. You can create a maximum of 128 non-default VRF instances. While you can assign management interfaces only to the management VRF instance, you can assign any physical or logical interface - VLAN, port channel or loopback, to a non-default VRF instance. When you create a new non-default VRF instance, OS10 does not assign any interface to it. You can assign the new VRF instance to any of the existing physical or logical interfaces, provided they are not already assigned to another non-default VRF. NOTE: When you create a new logical interface, OS10 assigns it automatically to the default VRF instance. In addition, OS10 initially assigns all physical Layer 3 interfaces to the default VRF instance. You can reassign any interface assigned to a non-default VRF instance back to the default VRF instance. • Create a non-default VRF instance by specifying a name and enter VRF configuration mode. CONFIGURATION ip vrf vrf-name Assign an interface to a non-default VRF instance After creating a non-default VRF instance you can associate an interface to the VRF instance that you created. To assign an interface to a non-default VRF, perform the following steps: 1 Enter the interface that you want to assign to a non-default VRF instance. CONFIGURATION interface ethernet 1/1/1 2 Remove the interface from L2 switching. INTERFACE 388 Layer 3