Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 535

Enable OSPFv2 in a non-default VRF instance To enable OSPFv2 in a non-default VRF instance: 1 Create a non-default VRF instance in which you want to enable OSPFv2: ip vrf vrf-name 2 Enable OSPF and configure an OSPF instance in VRF CONFIGURATION mode. router ospf instance-number vrf vrf-name 3 Enter the interface information to configure the interface for OSPF in INTERFACE mode. interface ethernet node/slot/port[:subport] 4 Enable the interface in INTERFACE mode. no shutdown 5 Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode. no switchport 6 Associate the interface with the non-default VRF instance that you created earlier. ip vrf forwarding vrf-name 7 Assign an IP address to the interface. ip address ip-address/mask 8 Enable OSPFv2 on the interface. ip ospf process-id area area-id • process-id-Enter the OSPFv2 process ID for a specific OSPF process, from 1 to 65535. • area-id-Enter the OSPFv2 area ID as an IP address (A.B.C.D) or number, from 1 to 65535. Enable OSPFv2 configuration OS10(config)# ip vrf vrf-blue OS10(config-vrf-blue)# router ospf 100 vrf-blue OS10(conf-router-ospf-100)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# no shutdown OS10(conf-if-eth1/1/2)# no switchport OS10(conf-if-eth1/1/2)# ip vrf forwarding vrf-blue OS10(conf-if-eth1/1/1)# ip address 11.1.1.1/24 OS10(conf-if-eth1/1/1)# ip ospf 100 area 0.0.0.0 NOTE: If you want to move an interface associated with one VRF instance to another default or non-default VRF instance, you must first remove the OSPF or Layer3 configurations that already exist on the interface. If you move the interface from one VRF instance to another without removing these existing Layer3 or OSPF configurations, these configurations do not take effect in the new VRF instance. Consider a scenario where the OSPF instance 100 is configured on the default VRF instance and the OSPF instance 200 is configured on the non-default VRF instance named VRF-Red. The interface eth1/1/1 on the default VRF instance is attached to an OSPF process 100 area 1. In this scenario, if you want to move eth1/1/1 from the default VRF instance to VRF-Red, you must first remove the OSPF area configuration to which the interface eth1/1/1 is currently attached to. Assign router identifier For managing and troubleshooting purposes, you can assign a router ID for the OSPFv2 process. Use the router's IP address as the router ID. • Assign the router ID for the OSPFv2 process in ROUTER-OSPF mode router-id ip-address Layer 3 535