Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 238

21:00:00:24:ff:7f:ce:ee 21:00:00:24:ff:7f:ce:ef Example (with zoneset name) OS10# show fc zoneset set ZoneSetName ZoneName ZoneMember set hba1 21:00:00:24:ff:7b:f5:c8 10:00:00:90:fa:b8:22:19 21:00:00:24:ff:7f:ce:ee 21:00:00:24:ff:7f:ce:ef hba2 20:01:00:0e:1e:e8:e4:99 50:00:d3:10:00:ec:f9:1b 50:00:d3:10:00:ec:f9:05 50:00:d3:10:00:ec:f9:1f 20:35:78:2b:cb:6f:65:57 Supported Releases 10.3.1E or later zone default-zone permit Enables access between all logged-in FC nodes of the vfabric in the absence of an active zoneset configuration. Syntax zone default-zone permit Parameters None Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information A default zone advertises a maximum of 255 members in the registered state change notification (RSCN) message. The no version of this command disables access between the FC nodes in the absence of an active zoneset. Example OS10(config)# vfabric 100 OS10(conf-vfabric-100)# zone default-zone permit Supported Releases 10.3.1E or later zoneset activate Activates an existing zoneset. You can activate only one zoneset in a vfabric. Syntax zoneset activate zoneset-name Parameters zoneset-name - Enter an existing zoneset name. Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information After you disable an active zoneset, the zone default-zone permit command configuration takes effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC nodes of the vfabric. The no version of this command deactivates the zoneset. 238 Fibre Channel